User`s manual

UC-7408 User’s Manual Getting Started

2-2

Powering on UC-7408

Connect the SG wire to the Shielded Contact located in the upper left corner of the UC-7408, and

then power on UC-7408 by connecting it to the power adaptor. It takes about 30 to 60 seconds for

the system to boot up. Once the system is ready, the Ready LED will light up, and the Network

address settings will appear on the LCM display.

NOTE After connecting UC-7408 to the power supply, it will take about 30 to 60 seconds for the

operating system to boot up. The green Ready LED will not turn on until the operating system is

ready.

Connecting UC-7408 to a PC

There are two ways to connect UC-7408 to a PC: through the serial Console port or via Telnet

over the network.

Serial Console

The serial console port gives users a convenient way of connecting to UC-7408’s console utility.

This method is particularly useful when using UC-7408 for the first time. The signal is transmitted

over a direct serial connection, so you do not need to know either of UC-7408’s two IP addresses

in order to connect to the serial console utility.

Use the serial console port settings shown below.

Baud rate

115200 bps

Parity

None

Data bits

Stop bits:

Flow Control

None

Terminal

VT100

Once the connection is established, the following window will open.

To log in, type the Login name and password as requested. The default values are both root:

Password: root