Manualshelf

User's Manual

ManualsBrandsMoxa ManualsElectronicsArm-based platform
11121314151617181920
UC-8100A-ME-T Series Hardware Hardware Introduction
5-2
WARNING
There is a risk of explosion if the battery is replaced with an incorrect type.
Real Time Clock
The UC-8100A-ME-T’s real time clock is powered by a non-chargeable battery. We strongly recommend that
you do not replace the lithium battery without help from a qualified Moxa support engineer. If you need to
change the battery, contact the Moxa RMA service team.
Installation Options
DIN-Rail Mounting
The aluminum DIN-rail attachment plate is already attached to the product’s casing. To mount the
UC-8100A-ME-T on to a DIN rail, make sure that the stiff metal spring is facing upwards and follow these steps.
1.
Pull down the bottom slider of the DIN-rail
bracket located at the back of the unit
2.
Insert the top of the DIN rail into the slot just
below the upper hook of the DIN-rail bracket.
3.
Latch the unit firmly on to the DIN rail as shown
in the illustrations below.
4.
Push the slider back into place.