User Manual

then click OK. If you select Dumb Terminal as the terminal type, some of the console
functions—especially the “Monitor” function—may not work properly.
6. Press the “ ` ” key continuously and then power on the NPort W2250/W2150.
7. NPort W2250/W2150 will receive the “ ` ” string continuously and then auto switch from data
mode to console mode.
8. Input the password when prompted. Note that this page will only appear when the NPort
W2250/W2150 has been set up for password protection.
9.Start configuring the IP address under Network Settings. Refer to the Telnet Console section
for the rest of the IP settings.