User Manual

1 to 65535 4001 Required
The UDP port that NPort 5200 listens to, and that other devices must use to contact NPort 5200.
To avoid conflicts with well known UDP ports, the default is set to 4001.
Serial Port Settings -> Communication Parameter
Port alias
Setting Factory Default Necessity
1 to 15 characters
(E.g., PLC-No.1)
None Optional
“Port alias” is included to allow easy identification of the serial devices that are connected to
NPort 5200’s serial port.
Serial Parameters
Check the serial communication parameters in your Serial Device’s user’s manual. You should set
up NPort 5200’s serial parameters with the same communication parameters used by your serial
devices.
Baud rate
Setting Factory Default Necessity
50 bps to 115.2 Kbps 115.2 Kbps Required