User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
3
3
Chapter 3 Initial IP Configuration
When setting up your NPort W2250/2150 for the first time, the first thing you should do is
configure the IP address. Select one of the initial IP Address configuration methods to configure
NPort W2250/2150’s IP Address. For more details about network settings, see the Network
Settings section from Chapter 5, Web Console Configuration.
This chapter covers the following topics:
Installation Procedure for First-time Users
Factory Default IP Address
ARP
Telnet Console
Serial Console (19200, n, 8, 1)