User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Initial IP Configuration
3-5
6. Type m and then press Enter to return to the main menu.
<< Main Menu->Network Settings->Ethernet Configuration >>
(1) IP Configuration
(2) IP Address
(3) Netmask
(4) Gateway
(v) View Settings
(m) Back to Main Menu
(q) Quit
Key in your selection: m
7. Type 8 and then press Enter to Save/Restart the system.
<< Main Menu >>
(1) Basic Settings
(2) Network Settings
(3) Serial Port Settings
(4) System Management
(5) Ping
(6) Change Password
(7) Load Factory Default
(8) Save/Restart
(v) View Settings
(q) Quit
Key in your selection: 8
8. Type y and then press Enter to save the new IP address and restart NPort W2250/W2150.
Ready to restart
(y) Yes
(n) No
Key in your selection: y