User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Initial IP Configuration
3-6
Serial Console (19200, n, 8, 1)
Before configuring the NPort W2250/2150 via the serial console, turn off the power and use a
serial cable to connect the NPort W2250/2150 to your computer’s serial port.
We suggest using MOXA PComm Terminal Emulator, which can be downloaded free of charge
from
www.moxa.com, to carry out the configuration procedure.
1. Connect NPort W2250/2150’s serial port 1 directly to your computer’s male RS-232 serial
port.
2. From the Windows desktop, click on Start Æ Programs Æ PComm Lite Æ Terminal
Emulator.
3. When the PComm Terminal Emulator window opens, first click on the Port Manager
menu item and select Open, or click on the Open icon.
4. The Property window opens automatically. From the Communication Parameter page,
select the appropriate COM port for the connection, COM1 in this example, and 19200 for
Baud Rate, 8 for Data Bits, None for Parity, and 1 for Stop Bits.