User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Initial IP Configuration
3-7
5. From the Property window’s Terminal page, select ANSI or VT100 for Terminal Type,
and click on OK. If you select Dumb Terminal as the terminal type, some of the console
functions—especially the “Monitor” function—may not work properly.
6. Press the “`” key (located in the upper left corner of the keyboard) continuously while
powering on the NPort W2250/2150.
7. Sending a continuous “`” string to NPort W2250/W2150 triggers it to switch automatically
from data mode to console mode.
8. Input the password when prompted. Note that this page will only appear when the NPort
W2250/2150 has been set up for password protection.
9. Start by configuring the IP address under Network Settings. Refer to the Telnet Console
section for instructions on how to configure the rest of the IP settings.