User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Web Console Configuration
5-3
ATTENTION
If you use a web browser other than Internet Explorer, remember to Enable the functions to
“allow cookies that are stored on your computer” or “allow per-session cookies.”
NPort W2250/2150 uses cookies only for “password” transmission.
Basic Settings
Time Settings
NPort W2250/2150 has a built-in Real-Time Clock that allows you to add real-time information to
functions such as Auto warning “Email” or “SNMP Trap.”
ATTENTION
First time users should select the time zone first. The Console will display the “real time”
according to the time zone compared to GMT. If you would like to modify the real time clock,
select “Local time.” NPort W2250/2150’s firmware will modify the GMT time according to the
Time Zone.
Time zone (24 hour)
Setting Factory Default Necessity
User selectable time zone GMT (Greenwich Mean Time) Optional
Local time
Setting Factory Default Necessity
User adjustable time
(1900/1/1-2037/12/31)
GMT (Greenwich Mean Time) Optional