User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Web Console Configuration
5-21
Communication Parameters
Port 01(02)
Port alias
Setting Factory Default Necessity
1 to 15 characters
(e.g., PLC-No. 1)
None Optional
“Port alias” is included to allow easy identification of the serial devices that are connected to
NPort W2250/2150’s serial port.
Serial Parameters
ATTENTION
Check the serial communication parameters in your Serial Device’s user’s manual. You should
set up NPort W2250/2150’s serial parameters with the same communication parameters used by
your serial devices.
Baud Rate
Setting Factory Default Necessity
110 bps to 230.4 Kbps 115.2 Kbps Required
Data Bits
Setting Factory Default Necessity
5, 6, 7, 8 8 Required
Stop Bits
Setting Factory Default Necessity
1, 2 1 Required