User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Web Console Configuration
5-22
Parity
Setting Factory Default Necessity
None, Odd, Even, Space, Mark None Required
Flow Control
Setting Factory Default Necessity
None, RTS/CTS, DTR/DSR,
XON/XOFF
RTS/CTS Required
FIFO
Setting Factory Default Necessity
Enable, Disable Enable Required
NPort W2250/2150’s serial ports provide a 16-byte FIFO both in the Tx and Rx directions. To
prevent data loss during communication, disable the FIFO setting when your serial device does not
have a FIFO.
Interface
Model Ports Settings Factory Default Necessity
NPort W2250 2 RS-232/422/485 RS-232 Required
NPort W2150 1 RS-232/422/485 RS-232 Required
System Management
Accessible IP Settings