User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Web Console Configuration
5-29
Load Factory Default
Click on Submit in the Load Factory Default page to reload the NPort W2250/W2150’s factory
default values. Keep in mind that all current settings will be lost.
Save/Restart
After making modifications to the NPort W2250/2150’s configuration, click on Submit in the
Save/Restart page to save the settings, and reboot the NPort W2250/2150.
ATTENTION
If you forget the password, the ONLY way to configure NPort W2250/2150 is by using the
Reset button on NPort W2250/2150’s casing to “Load Factory Default.”