User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Installing and Configuring the Software
6-2
Overview
The Documentation & Software CD included with your NPort W2250/2150 is designed to make
the installation and configuration procedure easy and straightforward. This auto-run CD includes
the NPort COM Driver (for COM mapping), NPort Search Utility (to broadcast search for all
NPort W2250/2150 accessible over the network), User’s Manual, and firmware upgrade utility.
Installing NPort COM Driver
1. Click on the INSTALL COM Driver button in the NPort Installation CD auto-run window
to install the NPort W2000 Series COM Driver.
2. Once the installation program starts running, click on Yes to proceed.
3. Click on Next when the Welcome window opens to proceed with the installation.