User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Installing and Configuring the Software
6-8
Configuring NPort COM Driver
The NPort COM Driver utility installs Real COM drivers that work under Windows
98/ME/2000/XP/2003. After you install NPort COM Driver, you can set up the NPort
W2250/W2150’s serial ports as remote COM ports for your PC host.
Use the following steps to map the COM ports:
1. Click on Start Æ Programs Æ NPort Windows Driver Manager Æ NPort COM
Mapping Utility to start the COM mapping utility.
2. Click on the Add icon.
3. Click on Rescan to search for NPort device servers, select the server you would like to map
COM ports to, and then click on OK.