User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Installing and Configuring the Software
6-9
4. Alternatively, you can select Input Manually and then input the NPort IP Address, 1
st
Data
Port, 1
st
Command Port, and Total Ports for the NPort W2250/2150 that you would like to
map COM ports to. Click on OK to proceed to the next step.
5. Click on Ye s to activate the COM ports at this time, or click on No to activate the COM ports
later. Activating the COM ports saves the information in the host system registry. The host