User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Installing and Configuring the Software
6-10
computer will not have the ability to use the COM port until you click on the Apply icon.
6. The display text corresponding to NPorts whose ports are activated will change from blue to
black.
7. To re-configure the settings for a particular NPort, click on the row corresponding to that
NPort to highlight it, and then click on the Setting icon.
8. In the Basic Setting panel, use the COM Number drop-down list to select a COM number
for the NPort’s first serial port. Since NPort W2250 has two ports, you can check mark the
Auto Enumerating COM Number for Selected Ports checkbox to automatically assign the
next available COM number to the second serial port. Note that ports that are “in use” will be
labeled accordingly.