User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Installing and Configuring the Software
6-12
much poorer operation performance than when using the native COM1 port. Once you
have enabled the “Fast Flush” function, you can check to see if there has been an
improvement in performance.
d. By default, the optional “Fast Flush” function is Enable. If you would like to enable
this function, double click on the COM ports that are mapped to the NPort, and then
select the “Fast Flush” checkbox. You should find that when “Fast Flush” is enabled, the
NPort driver will work faster with “PurgeComm().”
9. The program can redefine the serial parameters to different values after the program opens
the port via Win 32 API.
10. To save the configuration to a text file, select Export COM Mapping. You will then be able to
import this configuration file to another host and use the same COM Mapping settings in the
other host.