User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Initial IP Configuration
- Chapter 4 Choosing the Proper Operation Mode
- Chapter 5 Web Console Configuration
- Chapter 6 Installing and Configuring the Software
- Appendix A SNMP Agents with MIB II & RS-232 Like Groups
- Appendix B Well Known Port Numbers
- Appendix C Federal Communication Commission Interference Statement
- Appendix D FCC Warning Statement
- Appendix E Service Information
NPort W2250/2150 Plus User’s Manual Installing and Configuring the Software
6-13
Configuring NPort Search Utility
The Broadcast Search function is used to locate all NPort W2250/2150s that are connected to the
same LAN as your computer. After locating an NPort W2250/2150, you will be able to change the
IP address.
Since the Broadcast Search function searches by MAC address and not IP address, all NPort
W2250/W2150s connected to the LAN will be located, regardless of whether or not they are part
of the same subnet as the host.
1. Open the NPort Search Utility and then click on the Search icon.
2. The Searching window indicates the progress of the search.
3. When the search is complete, the NPort W2250/2150 units that were located will be
displayed in the NPort Search Utility window.