User's Manual
Table Of Contents
- 10. Web Console: Restart
- 11. Installing and Configuring the Software
- A. SNMP Agents with MIB II & RS-232-Like Groups
- B. Well Known Port Numbers
- C. Ethernet Modem Commands
- D. Federal Communication Commission Interference Statement
- E. FCC Warning Statement
NPort W2150A/W2250A Series Installing and Configuring the Software
11-6
2. Click [Rescan] to search the network for NPort device servers. In the list of NPort device servers that are
found, select the unit(s) that you will use for COM mapping and click [OK].
Alternatively, you can select Input Manually and manually enter the NPort IP Address, 1st Data Port,
1st Command Port, and Total Ports for the desired NPort unit. Click [OK] to proceed.