User's Manual
Table Of Contents
- 10. Web Console: Restart
- 11. Installing and Configuring the Software
- A. SNMP Agents with MIB II & RS-232-Like Groups
- B. Well Known Port Numbers
- C. Ethernet Modem Commands
- D. Federal Communication Commission Interference Statement
- E. FCC Warning Statement
NPort W2150A/W2250A Series Installing and Configuring the Software
11-16
Modifying NPort IP Addresses
1. Once NPort Search Utility has found NPort device servers on the LAN, you can modify any unit’s IP address.
Select the desired NPort in the main window and click [Assign IP] on the main toolbar. This will modify the
IP address for the active network connection (LAN or WLAN).
2. Enter the new IP address and netmask. If multiple units were selected, you may assign addresses
sequentially by clicking [Assign IP Sequentially]. Click [OK] to proceed.
3. The selected NPort will be restarted by NPort Search Utility with the new IP address.