User's Manual

NPort W2150A/W2250A Series Installing and Configuring the Software
5-19
/search Search the NPort and store the list to the memory.
/set Specify the ID to set. Users must specify one of the searched
NPorts for further operations. The default is 1.
/port Specify the NPort port number (PORT_NO) to set.
/password Specify the password (CIPHER) if the NPort has one.
/network Set to change the network settings.
/ip Change the IP address (IP_ADDR) of NPort.
/mask Change the subnet mask (SUBNET) of NPort.
/gateway Change the IP address (IP_ADDR) of gateway.
/apply Specify the ID to save changes and restart the NPort.
4. Examples
npcli /driver /install D:\Users\drvmgr_setup_Ver1.19.0_Build_15122492
npcli /driver /uninstall
npcli /driver /add 192.168.127.254 /port 1 /com 3
npcli /driver /add 192.168.127.254 /port 2 /com 4 /flush normal
npcli /device /search
npcli /device /set 1 /network /ip 192.168.10.7 /mask 255.255.255.0
/password moxa
npcli /device /apply 1
Note:
Npcli.exe requires an administrator privilege to change device settings.
It support only IPv4 and it must be run under Windows XP and later versions.
Linux Real TTY Drivers
Real TTY driver are provided that will map Linux host TTY ports to NPort serial ports. Once the mapping has
been set up, Linux users and applications can connect to a serial port as if it were a local TTY port. These
drivers have been designed and tested for the majority of Linux distributions, including Linux kernel version
2.4.x, 2.6.x, and 3.x, 4.x. Please check http://www.moxa.com
for the latest Linux kernel supported.
Basic Steps
Follow these instructions to map a TTY port to an NPort serial port:
1. Install the NPort device server and set the target device port to Real COM mode.
2. Install the Real TTY driver files on the Linux host.
3. Map the host’s TTY port to the target device port on the NPort.
Installing Linux Real TTY Driver Files
Before proceeding with the software installation, make sure you have completed the NPort device server has
been installed and configured correctly. Note that the default LAN IP address for the NPort is
192.168.126.254, whereas the default WLAN IP address is 192.168.127.254.
ATTENTION
The target serial port must be operating in Real COM mode in order to map TTY ports.
1. Obtain the driver file from https://www.moxa.com/support/support_home.aspx?isSearchShow=1
.
2. Log in to the console as a super user (root).
3. Execute cd / to go to the root directory.