User's Manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Configuration
- 4. Introduction to Operation Modes
- 5. Web Console: Basic Settings
- 6. Web Console: Network Settings
- 7. Web Console: Serial Port Settings
- 8. Web Console: System Management
- 9. Web Console: System Monitoring
NPort W2150A/W2250A Series Getting Started
2-3
LED Indicators
Top Panel LED Indicators
Name Color Function
Ready
Red
Steady on: Power is on and NPort is booting up.
Blinking: IP conflict or DHCP/ BOOTP server did not respond properly.
Green
Steady on: NPort is functioning normally.
Blinking: Unit is responding to Locate function.
Off Power is off or a power error condition exists.
WLAN
Green
Steady on: Wireless enabled
Blinking: NPort can’t establish WLAN connection with AP
(Infrastructure) or station (Ad-Hoc)
Off Wireless not enabled.
Serial 1
Serial 2
Orange Serial port is receiving data.
Green Serial port is transmitting data.
Off No data is flowing to or from the serial port.
Signal Strength
(5 LEDS)
Red
1 Red - the signal strength is between 0% and 20%
2 Red - the signal strength is between 21% and 40%
Green
3 Green - the signal strength is between 41% and 60%
4 Green - the signal strength is between 61% and 80%
5 Green - the signal strength is between 81% and 100%
End Panel LED Indicators
Name Color Function
Ethernet
Orange
10 Mbps Ethernet connection
Green
100 Mbps Ethernet connection
Off Ethernet cable is disconnected