User's Manual
Table Of Contents
- 1. Introduction
- 2. Getting Started
- 3. Initial IP Configuration
- 4. Introduction to Operation Modes
- 5. Web Console: Basic Settings
- 6. Web Console: Network Settings
- 7. Web Console: Serial Port Settings
- 8. Web Console: System Management
- 9. Web Console: System Monitoring
NPort W2150A/W2250A Series Web Console: System Management
8-10
Maintenance
Console Settings
The Console Settings page is located under Maintenance in the System Management folder. This is where
you enable or disable access to the various NPort configuration consoles, as well as the behavior of the reset
button. You may modify HTTP console, HTTPS console, Telnet console, SSH console, and Reset button.
HTTP Console
Default Enable
Options Enable, Disable
Description This field enables or disables access to the HTTP (web) console.
HTTPS Console
Default Enable
Options Enable, Disable
Description This field enables or disables access to the HTTPS (web) console.
Telnet Console
Default Enable
Options Enable, Disable
Description This field enables or disables access to the Telnet console.
SSH Console
Default Enable
Options Enable, Disable
Description This field enables or disables access to the SSH console.
Reset Button
Default Always Enable
Options Always Enable, Disable after 60 sec
Description This field specifies the behavior of the hardware reset button.
Always Enable: The reset button will be operate as usual.
Disable after 60 sec: The reset button will only be effective for the first 60 seconds that the
NPort is powered on.