User's Manual

W311/321/341 Hardware User’s Manual Hardware Connection Description
W341
The SD slot is located on the front panel of the W341. To install an SD card, you must first remove
the SD slot’s protective cover to access the slot, and then plug the SD card directly into the slot.
The SD card will be mounted at /mnt/sd. Detailed installation instructions are shown below:
Step 1: Use a screwdriver to remove the screws holding the SD slot’s outer cover, and then
remove the cover.
Step 2: Insert the SD memory card as shown.
NOTE: To remove the SD card from the slot, press the SD card in slightly with your finger, and
then remove your finger to cause the card to spring out partially. You may now grasp the top of the
card with two fingers and pull it out.
Before removing the SD card, remember to type /sync to ensure that your data has been written.
3-6