User Manual
WAPA003 User’s Manual Getting Started
FCC
Caution:
To assure continued compliance, (example - use only shielded interface cables when connecting to computer or
peripheral devices) any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT
NO
TE:
This module is restricted to mobile configuration. To comply with FCC RF exposure compliance requirements,
the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. This transmitter module must not be co-located or operating in conjunction with any other antenna
or transmitter
AntennaList
No. Manufacturer Part No. Antenna Type Peak Gain
1
KINSUN
SMA-Male-RP (main)(aux) Dipole
2dBi for 2.4GHz
2
KINSUN
ANT-WSB-ANM-05
(main)(aux)
Dipole 5dBi for 2.4GHz
3
KINSUN
ANT-WDB-ANM-0609
(main)(aux)
Dipole 6dBi for 2.4GHz
4
Antenna Technology
AT1515 Panel 11dBi for 2.4GHz
5
Antenna Technology
AT1524 Panel 8dBi for 2.4GHz
6 Antenna Technology AT1539 Panel 14dBi for 2.4GHz
7 DIAMOND TK2632 Panel 14dBi for 2.4GHz
Note:
1. The antenna of EUT conforms to FCC 15.203.
2. Only the higher gain antenna was tested and recorded in this report
3. Addition three new antenna (AT1515, AT1524, AT1539,
TK2632), antenna gain is higher with the
original application.
4. No.6 (Antenna Technology / AT1539) and No.7(DIAMOND/ TK2632) are same antennas with
different marketing name.
MoxaAmericasInc.
MoxaCorporatePlaza
601ValenciaAvenue,#100
Brea,California92823
Tel:1‐888‐MOXA‐USA(1‐888‐669‐2872)
+1‐714‐528‐6777
Fax:+1‐714‐528‐6778
Email:usa@moxa.com
Web:www.moxa.com