User's Manual

WAPA004 User’s Manual Getting Started
RF exposure warning
This equipment must be installed and operated in accordance with provided
instructions
and the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. End-users and installers must be
provide with antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied to an
OEM or integrator, but should not be distributed to the end user.
1) This device is intended for OEM integrators only.
2) Please see the full Grant of Equipment document for other restrictions.
This radio transmitter FCCID: SLE-WAPA004 has been approved by FCC to operate with the
antenna types listed below with the maximum permissible gain and required antenna
impedance for
each antenna type indicated. Antenna types not included in this list, having a gain greater
than the
maximum gain indicated for that type, are strictly prohibited for use with this device.
ANTENNA LIST
No. Manufacturer
Part No.
Peak Gain
1
KINSUN ANT-WDB-0-2 BK (main)(aux)
2.9dBi in 2.4 GHz
2.3dBi in 5 GHz
2
KINSUN ANT-WDB-ANM-0502 (main)(aux)
4.62dBi in 2.4 GHz
1.41dBi in 5 GHz
Note:The antenna connector is Reverse SMA type (ANT-WDB-0-2 BK) and N type (ANT-WDB-ANM-0502)
Note:
This is a specific product that requires professional installation and configuration, must be
performed by trained technical engineers to install the antenna, the MOXA agents contact
information as follows: