Quick Installation Guide

- 23 -
Certifications
FCC/IC Statements
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTE
This device is restricted to mobile configuration. To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter must be installed
to provide a separation distance of at least 50 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
This transmitter module must not be co-located or operating in conjunction with
any other antenna or transmitter
.
CAUTION
Any changes or modifications not expressly approved by the grantee of this
device could void the user's authority to operate the equipment.
This radio transmitter FCC ID: SLE-WAPC003 has been approved by FCC to
operate with the antenna types listed below with the maximum permissible gain
and required antenna impedance for each antenna type indicated. Antenna types
not included in this list, having a gain greater than the maximum gain indicated for
that type, are strictly prohibited for use with this device.
Antenna List
Item
Manufacturer
Model name
Type
2.4GHz Gain
5GHz Gain
1
MOXA
ANT-WDB-ANM-0306
Dipole
3
6
2
MOXA
ANT-WDB-ANM-0502
Dipole
5
2
3
MOXA
ANT-WDB-ARM-02
Dipole
2
2
4
MOXA
ANT-WDB-ARM-0202
Dipole
2
2
5
MOXA
ANT-WSB-AHRM-05-1.5m
Dipole
5
-
6
MOXA
MAT-WDB-CA-RM-2-0205
Dipole
2
5
7
MOXA
MAT-WDB-DA-RM-2-0203-1m
Dipole
2
3
8
MOXA
MAT-WDB-PA-NF-2-0708
Panel
7
8
9
MOXA
ANT-WDB-PNF-1011
Panel
10
11
10
MOXA
ANT-WDB-ONM-0707
Dipole
7
7
11
MOXA
ANT-WDB-ONF-0709
Dipole
7
9
12
MOXA
ANT-WSB5-PNF-16
Panel
-
16
13
MOXA
ANT-WSB-PNF-12-02
Panel
12
-
maximum conduct output power:
Antenna TYPE: Dipole: 2.4G : 0.7211W, 5G: 0.4819W
Antenna TYPE: Panel: 2.4G: 0.6194W, 5G: 0.4819W