User Manual

AirWorks AWK-3131A Introduction
1-6
LED Color State Description
Front Panel LED Indicators (System)
PWR1 Green
On Power is being supplied from power input 1.
Off Power is not being supplied frompower input 1.
PWR2 Green
On
Power is being supplied from power
input 2.
Off
Power is not being supplied from
power input 2.
PoE Amber
On Power is being supplied via PoE.
Off Power is not being supplied via PoE.
FAULT Red
Blink
(slow)
Cannot get an IP address from the
DHCP server (interval: 1 sec)
Blink
(fast)
IP address conflict (interval: 0.5 sec)
Off Error condition does not exist.
STATE
Green/
Red
Green Software Ready
Green
Blink
The AWK has been located by AWK
Search Utility. (interval: 1sec)
Red Booting error condition
SIGNAL
(5 LEDs)
Green
On Signal level(for Client/Slave mode only)
Off
WLAN
Green
On
WLAN function is in Client/Slave mode and AWK has established a link
with an AP.
Blink WLAN data communication is run in Client/Slave mode
Off
WLAN is not in Client Mode or AWK has not established a link with an
AP.
Amber
On WLAN functions in AP/Master mode.
Blink WLAN’s data communication is run in AP/Master mode
Off WLAN is not in use or not working properly
LAN
Green
On LAN port’s 1000 Mbps link is active.
Blink Data is being transmitted at 1000 Mbps
Off LAN port’s 1000 Mbps link is inactive
Amber
On LAN port’s 10/100 Mbps link is active.
Blink Data is being transmitted at 10/100 Mbps
Off LAN port’s 10/100 Mbps link is inactive
ATTENTION
When the system fails to boot, the LEDs for STATE (Green), FAULT, and WLAN will all light up
simultaneously and blink at one-second intervals. This may be due to improper operation or uncontrollable
issues, such as an unexpected shutdown while updating the firmware. To recover the firmware, refer to the
“Firmware Recovery” section in Chapter 6.
Beeper
The beeper emits two short beeps when the system is ready.
Reset Button
The RESET button is located on the top panel of the AWK-3131A. You can reboot the AWK-3131A or reset it to
factory default settings by pressing the RESET button with a pointed object such as an unfolded paper clip.
• System reboot: Hold the RESET button down for under 5 seconds and then release.