User Manual

AirWorks AWK-3131A Web Console Configuration
3-9
NOTE When you switch to Client mode, a Site Survey button
will be available on the Basic Wireless Settings panel.
Click the “Site Survey” button to view information about available APs, as shown in
the following figure. You can
click on the SSID of an entity and bring the value of its SSID onto the SSID field of the
Basic Wireless Settings
page. Click the Refresh button to re-scan and update the table.
NOTE
If the Gateway field in Basic Settings  Network Settings is empty, a warning message will appear,
reminding you to set the default gateway when Client mode is enabled. You can ignore this message if you
are
only planning a local network and packets will not be sent outside the network.
RF type
Setting Description Factory Default
2.4 GHz
B Only supports the IEEE 802.11b standard B/G/N Mixed
G Only supports the IEEE 802.11g standard
B/G Mixed Supports IEEE 802.11b/g standards, but 802.11g may operate
at a slower speed if when 802.11b clients are on the network
G/N Mixed Supports IEEE 802.11g/n standards, but 802.11n may operate
at a slower speed if 802.11g clients are on the network
B/G/N Mixed Supports IEEE 802.11b/g/n standards, but 802.11g/n may
operate at a slower speed if 802.11b clients are on the network
N Only (2.4GHz) Only supports the 2.4 GHz IEEE 802.11n standard
5 GHz
A Only supports the IEEE 802.11a standard
A/N Mixed Supports IEEE 802.11a/n standards, but 802.11n may operate
at a slower speed if 802.11a clients are on the network
N Only (5GHz) Only supports the 5 Ghz IEEE 802.11n standard