Manualshelf

User Manual

ManualsBrandsMoxa ManualsElectronicsIndustrial 802.11a/b/g/n AP/Client/Bridge
31323334353637383940
AirWorks AWK-3131A Web Console Configuration
3-18
Noise protection
Setting Description Factory Default
Enable/Disable Adjusts the interference coping capability of the wireless signal.
This option should be enabled for communication distance
under 500 meters, and should be disabled for communication
distances over 500 meters.
Disable
NOTE
Make sure the same Transmission distance parameters are set in both AP and Client. When this
parameter is greater than 500, an optimal algorithm will be enabled to support long-distance transmission.
Note that Transmission enhancement only supports 802.11a/n mode; 802.11b/g/n mode is not
supported.
Transmission enhancement is also recommended to enable communication at both ends when
long-distance transmission is required. A high-
gain antenna installed at a fixed antenna connector can also
improve performance.
WMM
Setting Description Factory Default
Enable/Disable WMM is a QoS standard for WLAN traffic. Voice and video data
will be given priority bandwidth when enabled with WMM
supported wireless clients.
Note: WMM will always be enabled under 802.11n mode.
Enable
Full 11a channel support
Setting Description Factory Default
Enable/Disable “Full 11a channel support” allows users to select one channel
from 802.11a, including channels in licensed and unlicensed
bands.
Disable
Turbo Roaming (for Client mode only)
Setting Description Factory Default
Enable/ Disable Moxa’s Turbo Roaming can enable rapid handover when the
AWK-3131A, as a client, roams among a group of APs.
Disable
When Turbo Roaming is enabled, the RF type, AP alive check, and Scan channels will be shown as follows. RF
type shows the current RF type that this client is using. AP alive check will check if the AP connection is still
available. When this function is enabled, a check will be done every 10 ms. You can set up Scan channels for
the APs among which this client is going to roam. There are three Scan channels available. Note that the Scan
channels may need to be modified when the RF type is changed. (For example, channel 36 is not available in
B, G, N or B/G/N Mix mode.)