User's Manual



WAPN005 User's Manual  Getting Started 

GPIO  2  UR_DTR  53  54  EMDC  GIGA  PHY 
GND  GND  55  56  EMDIO  GIGA  PHY 
GPIO  11  Reset  57  58  GND  GND 
GND  GND  59  60  GND  GND 
GPIO  12  LAN  10/100  61  62  TXP0  10/100  LAN 
GND  GND  63  64  TXN0  10/100  LAN 
GPIO  15  Reserved  65  66  GND  GND 
GND  GND  67  68  RXP0  10/100  LAN 
SYS_RST_L  GIGA  PHY  Reset  69  70  RXN0  10/100  LAN 
AVDD18  Fast  Ethernet  bios  71  72  GND  GND 
AVDD18  Fast  Ethernet  bios  73  74  GND  GND 
AVDD18  Fast  Ethernet  bios  75  76  USB_DM  USB  port 
GND  GND  77  78  USB_DP  USB  port 
GND  GND  79  80  GND  GND 


Hardware  Installation 
Followthesestepstoinstallthehardwarecomponents.
1.AttachtheWLANantennatotheconnectorJ1.
2.AttachthesecondWLANantennatotheconnectorJ2.
3.ConnecttheWAPN005moduleonthesystemboardwiththeboard-to-boardconnectorandgentlypressthe
boardontothestack.Theboardshouldslideintothematchingbusconnectors.Donotattempttoforcethe
board,asthepinsmaybedistortedorbroken.
4.UsethescrewstofastentheWAPN005module.
5.Ifyourequirethepowerboard,installitabovetheWAPN005module.
6.Fastenallcomponentsonthenecessarychassis.

Software  Installation 
Followthesestepstoinstallthesoftware.
1.Poweronthesystemboard.
2.ConnectsystemboardandPCwithanEthernetcable.
3.Openabrowserandtype:192.168.127.253toopenthesystemloginwebpage.
4.Loginthewebpagewithdefaultpassword: root toverifyallofthehardwarecomponentshavebeen
installedproperly.















2-5