User Manual

AirWorks AWK-3131A Introduction
LED Color State Description
Front Panel LED Indicators (System)
PWR1 Green
On Power is being supplied from power input 1.
Off Power is not being supplied frompower input 1.
On
Power is being supplied from power
input 2.
PWR2 Green
Off
Power is not being supplied from
power input 2.
PoE Amber
On Power is being supplied via PoE.
Off Power is not being supplied via PoE.
Blink Cannot get an IP address from the
(slow) DHCP server (interval: 1 sec)
FAULT Red Blink IP address conflict (interval: 0.5 sec)
(fast)
Off Error condition does not exist.
Green Software Ready
STATE
Green/ Green The AWK has been located by AWK
Red Blink Search Utility. (interval: 1sec)
Red Booting error condition
SIGNAL
Green
On Signal level(for Client/Slave mode only)
(5 LEDs) Off
On
WLAN function is in Client/Slave mode and AWK has established a link
with an AP.
Green Blink WLAN data communication is run in Client/Slave mode
WLAN Off
WLAN is not in Client Mode or AWK has not established a link with an
AP.
On WLAN functions in AP/Master mode.
Amber Blink WLAN’s data communication is run in AP/Master mode
Off WLAN is not in use or not working properly
On LAN port’s 1000 Mbps link is active.
Green Blink Data is being transmitted at 1000 Mbps
LAN
Off LAN port’s 1000 Mbps link is inactive
On LAN port’s 10/100 Mbps link is active.
Amber Blink Data is being transmitted at 10/100 Mbps
Off LAN port’s 10/100 Mbps link is inactive
ATTENTION
When the system fails to boot, the LEDs for STATE (Green), FAULT, and WLAN will all light up
simultaneously and blink at one-second intervals. This may be due to improper operation or uncontrollable
issues, such as an unexpected shutdown while updating the firmware. To recover the firmware, refer to
the “Firmware Recovery” section in Chapter 6.
Beeper
The beeper emits two short beeps when the system is ready.
Reset Button
The RESET button is located on the top panel of the AWK-3131A. You can reboot the AWK-3131A or reset it to
factory default settings by pressing the RESET button with a pointed object such as an unfolded paper clip.
• System reboot: Hold the RESET button down for under 5 seconds and then release.
1-6