User's Manual

NE-4100 Series User’s Manual Web Console Configuration
6-20
mail boxes when the enabled events—such as Cold start, Warm start, Authentication failure,
etc.—occur. To configure this feature, click on the event type box.
Trap
Setting Factory Default Necessity
Enable, Disable Disable Optional
This feature helps the administrator manage the WE-2100T. WE-2100T sends SNMP Trap to a
pre-defined SNMP Trap server when the enabled events—such as Cold start, Warm start,
Authentication failure, etc.—occur. To configure this feature, you need to click on the event type
box.
DCD changed and DSR changed events are only supported by those models that have these two
signals.
Digital IO
Click on the Digital IO link on the left side of the screen to open the DIO Settings window.
There are 2 options for selecting DIO modes: IN and OUT. When you set the mode to IN, you
will not be able to set the Status to H or L. You can only monitor the DIOs’ status. But when you
set the mode to OUT, you can configure the Status to H or L. Make necessary changes to the
settings and click on submit to validate the modifications.
Refer to Chapter 8 for information about the SW Reset Function.
DIO Monitor
You can monitor the DIO status from the web page shown below. To do so, click on the DIO
Monitor link on the left side of the screen to open the DIO Monitor window.