User's Manual

iii. End User’s mishandling, misuse, negligence, or improper installation, disassembly, storage, servicing or operation of the
Product.
iv. Modifications or repairs not made by KonnectONE or a KonnectONE-certified individual.
v. Power failures, surges, fire, flood, accidents, actions of third parties or other events outside KonnectONE’s reasonable
control.
vi. Usage of third-party products, or usage in conjunction with third-party products provided that such defects are due to the
combined usage.
vii. Any other cause beyond the range of normal usage intended for the Product.
• End User shall have no right to reject or return the Product, or receive a refund for the Product from KonnectONE under
the above-mentioned situations.
• This warranty is End User’s sole remedy and KonnectONE’s sole liability for defective or nonconforming items, and is in
lieu of all other warranties, expressed, implied or statutory, including but not limited to the implied warranties of
merchantability and fitness for a particular purpose, unless otherwise required under the mandatory provisions of the law.
Limitation of Liability
KonnectONE shall not be liable for any loss of profits or indirect, special, incidental or consequential damages resulting from
or arising out of or in connection with using of this product, whether or not KonnectONE had been advised, knew or should
have known of the possibility of such damages, including, but not limited to lost profits, interruption of business, cost of
capital, cost of substitute facilities or product, or any downtime cost.
Radio Frequency (RF) Energy
This model device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of the U.S. Government:
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using standard operating positions accepted by the
FCC with the device transmitting at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the device while operating can be well below the
maximum value. This is because the device is designed to operate at multiple power levels so as to use only the position
required to reach the network. In general, the closer you are to a wireless base station, the lower the power output.
The highest SAR value for the model device as reported to the FCC when worn on the body, as described in this user guide,
is 1.06W/kg, For body operation, this device has been tested and meets the FCC RF exposure guidelines for use with an
accessory that contains no metal and the positions the device a minimum of 1.0 cm from the body.
While there may be differences between the SAR levels of various devices and at various positions, they all meet the
government requirement.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be
found under the Display Grant section of http://www.fcc.gov/oet/ea/fccid/ after searching on
FCC Compliance
FCC ID: 2APQU-K779HSDL