Dishwasher User Manual

2
!
INSTALLATION
INSTALLATION (CONT.)
ELECTRICAL CONNECTIONS
NOTE:
Leave enough electrical cable behind the machine so that the dishwasher can be pulled
forward a minimum of two feet to be serviced.
WARNING:
Electrical and grounding connections must comply with the National Electrical Code and/or
Local Electrical Codes.
WARNING:
When working on the dishwasher, disconnect the electric service and tag it to indicate work
is being done on that circuit.
1. The electrician should compare the electrical specifications on the machine electrical data
plate (located in the control panel) to the electrical power supply before connecting the
machine to the incoming service at a fused disconnect switch.
NOTE:
The 208-240V/60Hz/1PH electrical supply service for this machine must be a 2-wire plus
ground service. For optional 208-240V/60Hz/3PH the electrical supply service must be a 3-
wire plus ground service.
2. On the 208V-240V models, a knockout is provided at the rear of the junction box for
electrical service connections. A fused disconnect switch or circuit breaker (supplied by
user) is required to protect each power supply circuit.
PLUMBING CONNECTIONS
CAUTION:
Plumbing connections must comply with local health and plumbing codes.
Water Connections
1. Connect the hot water supply to the fill hose provided with a 3/4" NPT fitting.
2. Install a manual shut-off valve in the water supply line to accommodate servicing the
machine. The shut-off valve should be the same size or larger than the supply line.
3. Install a 3/4" pressure reducing valve (PRV) (supplied with machine) in the water supply
line, and set at 22PSI/151kPa.