User's Manual

9
Two Camera Mounting Ways By default, the camera handle side is located near the tilt motor to allow an unobstructed access to the camera control ports; however under some special circumstances, the camera control ports side should be located near the tilt motor. Rightward installation is required under the following situations: The camera size is too wide like BMPPC. A specialized camera cage is used. The camera lens is too heavy to adjust the balance Rightward Installation steps: Mount the L-Bracket at the bottom of the camera with the short end near the
side of the lens;
Rotate the roll arm 180° until the tilt motor is located at the left side of the roll
motor;
Mount the shorter end of the L-Bracket on the release baseplate.
Regular installation Rightward installation
Notes: Some camera cages are equipped with ARCA standard release plate. These special cages can be mounted directly on the AirCross 2 gimbal without using the L-Bracket. For those cages that don’t have ARCA release plate, users can fix the ARCA plate (included in the AirCross 2 package) to the side of the cage with 1/4” screw. When camera is mounted in this way, the camera control port or HDMI port will be blocked.