User's Manual

Follow Modes

The AirCross 2 gimbal has 4 follow modes:

a. Pan follow mode: The pan axis will follow operator’s left and right movements

to achieve following shots with left and right turns.

b. Tilt follow mode: The tilt axis follows the operator's up and down movements to

achieve shots from low angle to high angle.

c. Pan-tilt follow mode: Both the pan and tilt axis will follow the operator's

movements.

d. All lock mode: The camera's shooting direction is fixed and will not follow the

operator's movements. It’s suitable for following shots in a straight line.

The following state and speed of each axis are displayed on the main interface of

the OLED screen. 'L' indicates that the axis is locked, and 'F' indicates that the axis

follows.

FPV mode

In the FPV (First Person View) mode, all three axes of the AirCross 2 will start

following to achieve first-person view shooting.

Inception Mode

To make 360° rotated videos. Press the right button of the dial to enter the

Inception Mode. Then the lens will automatically face up, the tilt motor will start to

follow, and the OLED screen will display the rotation speed. Turn the joystick

leftwards or rightwards or turn the dial to adjust the direction and speed of the

gimbal rotation. When shooting completes, press the right button on the dial

again to exit Inception Mode.

Manual positioning

The manual positioning function allows the operator to directly twist the motor to

adjust the position of each axis. It is faster and more convenient than using the

joystick or follow function to adjust the position. The manual positioning function

of the tilt axis is enabled by default, and the manual positioning function of the

other axes needs to be turned on in the menu.

Sport Gear Mode

In the Sport Gear Mode, the pan motor maintains the maximum locking force to

achieve fast transition effects.

Note:

The follow function has greater priority than the manual positioning. If the

following function of an axis is turned on, the manual positioning function is

automatically disabled. Manual positioning can only be used after the follow

function of the axis has been turned off.