User's Manual
17
Balance Check
The gimbal can check the balance status of each axis automatically and guide
the user to adjust correctly.
a. Attach a tripod to the gimbal, turn on the gimbal and place it on a horizontal
tabletop.
b. Enter the menu, select advanced>Balance chk, and the gimbal begins to
check the balance adjustment.
Back-*-front: the back/front position of the camera
If the * is close to back, the camera’s position is backward and needs to be adjusted forward;
If the * is close to front, the camera’s position is forward and needs to be adjusted backward.
Down-*-up: the down/up position of the tilt axis
If the * is close to down, the tilt arm’s position is too low and needs to be adjusted upwards;
If the * is close to up, the tilt arm’s position is too high and needs to be adjusted downward.
Left-*-right: the left/right position of the roll axis
If the * is close to the left, the roll arm’s position is too left and needs to be adjusted to the right;
If the * is close to right, the roll arm’s position is too right and needs to be adjusted to the left.
Offset
In case of emergency shooting, the camera cannot be leveled and there is no time for
sensor calibration, the camera can be adjusted to a horizontal state by offset.
a. Turn on the gimbal and the camera level, check the offset of the tilt and yaw axis.
b. Enter the menu, select advanced>calibrate>offset, select an axis that is not horizontal,
and then turn the dial to adjust the fine adjustment value of the axis until the camera
completely keeps level.
Notes: Balance check can be only used with the tilt and roll axis, the pan axis balance can’t
be checked. Be sure that the motor lock has been released when using balance check.
Notes:
The offset can only adjust the angle of each axis within the range of about ±5°, if there is too
much offset, the camera cannot be completely leveled.
Offset is only a temporary solution, after shooting, accelerometer calibration is still needed.
The parameters of the offset will not be saved and will become invalid after restart.
,URRU]LUI[Y ,XUTZ(GIQ
/TIKVZOUTSUJK ;V*U]T
3GT[GRVUYOZOUTOTM 2KLZ8OMNZ
(GRGTIKINKIQ $
-_XUYIUVK :ORZ
'IIKRKXUSKZKX 8URR
5LLYKZ $ 6GT