User's Manual

Firmware Upgrade

Upgrade via computer:

a. Turn off the gimbal.

b. Long press the joystick, then press the power button with the other hand until

the prompt ‘Boot Mode’ appears on the screen.

c. Connect the gimbal to the computer with a USB Type-C cable.

d. The software will automatically identify the device and load the firmware. Press

the ‘Upgrade’ button and wait for about 30s.

e. Restart the gimbal after the upgrade.

Upgrade via App:

a. Turn off the gimbal.

b. Long press the joystick, then press the power button with the other hand until

the prompt ’Boot Mode’ appears on the screen.

c. Launch the App, turn on the Bluetooth to search for the AirCross 2 nearby and

connect.

d. The App will automatically enter the firmware upgrade interface, please wait

for the firmware download to complete, press the ‘upgrade’ button and wait

for about 5 minutes.

e. Restart the gimbal after the upgrade.

Notes:

Make sure the gimbal is fully charged and the computer or mobile phone network

connection is normal during the upgrade.

Do not disconnect the gimbal from power, USB cable or Bluetooth during the

upgrade, otherwise the upgrade will fail.

Please re-install the batteries and try to upgrade again until the upgrade is

completed.