User Manual

The payload of AirCross 2 is from 300g to 3200g. Dierent payload requires dierent motor

power to achieve the best stability. There are three methods for adjusting the output of the

motor:

Auto-tuning operation method:

a. Install the camera and adjust the balance

b. Unlock all motor locks

c. Turn on the stabilizer, long press the center button to enter the menu, select ‘Gimbal’ >

'Motor' > ‘Power’ > ‘Auto-tune’

d. During the auto-tuning, the stabilizer will vibrate automatically to match the most suitable

output value. Wait for about 5 seconds, the stabilizer stops shaking, and the auto-tuning

completes.

Set the output gear:

Factory default presets 5 groups of motor output values, which are suitable for cameras of

dierent weight levels.

Customize the output value of each motor:

The users can customize the output value of each motor to reach more precise control of the

motor output. The adjustment range is 0 to 100.

Note:

1. Cameras equipped with Micro USB 3.0 interface, such as the Nikon D850, can be

normally controlled by half plugging the M3C-Micro cable.

2. After plugging the camera control cable, please operate the camera according to the

prompts on the camera screen, otherwise the camera control function may not work

properly.

Note:

1. Under the camera lens combination of the limit, the auto-tuning function may not accurately calculate the

appropriate output value. Please manually adjust the motor output according to the situation.

2. If the motor output is too low, the shooting picture will not be stable enough; if the motor output is too

high, it will cause high-frequency vibration of the stabilizer.

3. When the motor output is at the critical value, the stabilizer will not vibrate in the upright state, but it will

vibrate in the forward or inverted state. Please reduce the motor output moderately.

Motor Output

camera > motor > switch aututune

gimbal > follow > power > level

advanced > operation > filter > custom

general >

c. After selecting the camera type and connecting the camera control cable, press the menu button once to

achieve recording and press it twice to achieve photo taking.