User Manual
12
Balance Check
The Inception Mode is used to control the camera to rotate in the roll direction for
shooting upside down and rotating footages. In the main interface, triple click the right
button to enter the Inception Mode.
After entering the Inception Mode, the camera lens is vertically up and each axis
automatically follows.
Button Denition for Inception Mode:
●
Turn the joystick left or right: the gimbal turns to left or right, when release or turn
The gimbal can check the balance status of each axis automatically and instruct users
to make the correct adjustment.
a. Attach a tripod to the gimbal, turn on the gimbal and place it on a horizontal
tabletop.
b. Enter the menu, select advanced>balance chk, the gimbal begins to check the
balance adjustment.
c. When balance check is completed, the balance status of each axis will be displayed
on the screen, direction guide will be also displayed if the adjustment is needed.
d. C means quick release plate, T means tilt axis, R means roll axis, the direction can be
viewed at the corresponding position of the gimbal, then start the adjustment
according to the screen prompts.
e. When adjustment is completed, press the right button and check it again until the
gimbal is well balanced.
Note:
Balance check can be only used with the tilt and roll axis, the pan axis balance
can’t be checked.
Be sure that the motor lock has been released when using balance check.
Triple click the right button again to exit the Inception Mode.
to a specied angle, the gimbal stops.
●
Turn the dial: adjust the rotation speed
●
Press the left button on the dial once: the gimbal rotates to the left automatically.If
the gimbal is rotating, press once to stop.
●
Press right button on the dial once: the gimbal rotates to the right automatically.If
the gimbal is rotating, press once to stop.
●
Press up/down button on the dial: select rotationangle
●
Normal: gimbal rotatesand does not stop automatically
●
180: the gimbal rotates 180° and stops automatically.
●
360: the gimbal rotates 360° and stops automatically.
camera > autotune C adjust to +
gimbal > balance chk checking T adjust to -
advanced > iFocus > R well balanced
general > inception > exit
Inception Mode
< Speed：50 >
Normal 180 360
Inception Mode
< Speed：50 >
Inception Mode
< Speed：50 >
Normal 180 360Normal 180 360