User Manual

13
Accelerometer Calibration
Turn on the gimbal and there is no obvious drift, the accelerometer calibration is required
when the camera doesn’t keep level. The steps are as follows:
a. Turn on the gimbal（long press the power button）
b. Turn o the motors（double press the power button/enter the menu, select gimbal>mo-
tor>switch, set ‘o’）
c. Leave the L-shaped quick release plate on the horizontal table. Avoid the bottom screw and keep
the AirCross 2at static position. Do not shake the it or tilt it. (or mount the camera to refer to its
level)
d. Enter the menu, select advanced>calibrate>Acc cali, and press the dial right button to enter
calibration. Wait about 5 seconds, when the ‘？’ changes to ‘OK’, the calibration is
completed.
Note：
1.Please keep the gimbal stationary during the calibration, any shaking will cause the calibration
to deviate. 2.Any drastic shaking might cause ’err’ shown on the screen, please calibrate again.
3.Do not arbitrarily perform calibration operations while it is not necessary.
Gyroscope Calibration
Turn on the gimbal and leave it quietly for about 5 minutes, the gyroscope calibration is
required when the gimbal drifts obviously. The steps are as follows:
a. Turn on the gimbal（long press the power button）
b. Turn o the motors（double press the power button/enter the menu, select
gimbal>motor>switch, set ‘o’）
c. Leave the AirCross 2 on the table and don't shake it or the desktop.
d. Enter the menu, select advanced>calibrate>Gyro cali and press the dial right button, wait
about 5 seconds, when the ‘？’ changes to ‘OK’, the calibration is completed.
Oset
In case of emergency shooting, the camera cannot be leveled and there is no time for sensor
calibration, the camera can be adjusted to a horizontal state by oset.
a. Turn on the gimbal and the camera level, check the oset of the tilt and yaw axis.
b. Enter the menu, select advanced>calibrate>oset, select an axis that is not horizontal, and
then turn the dial to adjust the ne adjustment value of the axis until the camera
completely keeps level.
Sensor Calibration
camera > iFocus > gyro gyro ok
gimbal > inception > acc acc
advanced > manual po
s >
> angle offs
et
> angle offs
et
>
general > calibration >
camera > iFocus > gyro gyro
gimbal > inception > acc acc ok
advanced >
manual pos >
>
angle offset
>
angle offset
>
general > calibration >