User Manual

15
The AirCross 2 is equipped with a Manfrotto quick release baseplate and a plate which
make it facile for users to change shooting equipment. When using the Manfrotto
quick release system, please install the baseplate onto the longer end of the L-Bracket,
so that the knob screw onto the baseplate is exposed. Then x the camera onto the
release plate.
By default, the camera handle side is located near the tilt motor to allow an
unobstructed access to the camera control ports; however under some special
circumstances, the camera control ports side should be located near the tilt motor.
Rightward installation is required under the following situations:
a. The camera size is too wide like BMPCC.
b. A specialized camera cage is used.
c. The camera lens is too heavy to adjust the balance
Notes:
1. Some camera cages are equipped with ARCA standard release plate. These special
cages can be mounted directly on the AirCross 2. gimbal without using the L-Bracket.
2.Some special cages have no Arca standard quick release plate on the side ,TheArka
quick release plate can be mounted on the side of the camera rabbit cage with a 1/4"
screw and then mounted to AirCross 2. 3.When camera is mounted in this way, the camera
control port or HDMI port will be blocked.
Extension
Manfrotto Quick Release System
Two Camera Mounting Directions
Regular installation Rightward installation
Rightward Installation steps:
a. Mount the L-Bracket at the bottom of the camera with the short end near the side of
the lens;
b. Rotate the roll arm 180° until the tilt motor is located at the left side of the roll
motor;
c. Mount the shorter end of the L-Bracket on the release baseplate.