User Manual

Mounting the Camera

Horizontal Mounting

Vertical Mounting

Use the Arka quick release plate for vertical shot:

Balancing

a. Place the longer side of the L-Bracket under the

camera, and lock the camera with a 1/4”screw.

a. Place the arka-swiss quick release plate

horizontally under the camera and use a 1/4"

screw to lock the camera;

Note: The camera can only be installed vertically using the Arka quick release plate. It does not

block the camera's battery port and memory card slot.

b. Loosen the quick-release knob and pull out the safety

lock at the end of the quick-release knob. Install the Arka

quick-release plate into

the quick-release base. Then lock the knob.

a. Place the longer side of the L-Bracket under the

camera, and lock the camera with a 1/4”screw.

b. Loosen the quick release knob screw, Pull out the safety

lock at the end of the quick-release knob, insert the shorter

end of the L-Bracket into the quick release baseplate, and

then lock the knob.

a. Loosen the knob of the tilt arm, adjust the tilt

arm back and forth until the lens moves

horizontally forward, and then lock the knob.

b. Rotate the camera to make its lens face

upward, loosen knob on the release plate, adjust

the release plate back and forth until the lens

faces straight upward, and then lock the knob.

b. Loosen the quick release knob screw, pull out

the safety lock, insert the longer end of the

L-Bracket into the quick release baseplate, and

then lock the knob.