User's Manual

8
Mounting the Camera
Horizontal Mounting
Vertical Mounting
Use the Arca-Swiss quick release plate for vertical shot:
Balancing
a. Place the longer side of the L-Bracket
under the camera, and lock the camera
with a 1/4”screw.
a. Place the Arca-Swiss quick release
plate horizontally under the camera
and use a 1/4" screw to lock the
camera;
Note: The camera can only be installed vertically using the Arca-Swiss quick release
plate. It does not block the camera's battery port and memory card slot.
b. Loosen the quick-release knob and pull out
the safety lock at the end of the quick-release
knob. Install the Arca-Swiss quick-release plate
into the quick-release base. Then lock the knob.
a. Place the longer side of the L-Bracket
under the camera, and lock the camera
with a 1/4”screw.
b. Loosen the quick release knob screw, Pull out
the safety lock at the end of the quick-release
knob, insert the shorter end of the L-Bracket into
the quick release baseplate, and then lock the
knob.
a. Loosen the knob of the tilt arm, adjust
the tilt arm back and forth until the lens
moves horizontally forward, and then lock
the knob.
b. Rotate the camera to make its lens
face upward, loosen knob on the release
plate, adjust the release plate back and
forth until the lens faces straight upward,
and then lock the knob.
b. Loosen the quick release knob screw,
pull out the safety lock, insert the longer
end of the L-Bracket into the quick release
baseplate, and then lock the knob.