User's Manual

12
Notes:
1. If there is a “*” at the right side of one item, the current list is the final option, press
the dial right button to launch it.
2. If the selected item and other items in the menu list don’t have any marks, press the
dial right button to launch the option once. “>” is displayed during the process. “ok” is
displayed after the process is completed, and “err” is displayed if the option fails.
Menu type introduction:
If there is a “＞”mark at the right side of the selected item, press the dial
right button for the next menu.
If the selected item has a “[ ]”and contains a number, rotate the dial to
adjust its value.
If the selected item has a “()”and contains an option, press the right
button to switch among options
L1 L2 L3 L4 L5 Value Function
dial +/- rotate the dial clockwise to increase/decrease value
on/off turn on/off LED light on the wheel
0-100 adjust the brightness
？/ok auto tune
balance chk check the balance state of camera
switch ？/ok/err turn on/off the focus motor 1
set A ？/ok/err set the point A of focus motor 1
set B ？/ok/err set the point B of focus motor 1
Clear AB ？/ok/err Clear the calibration information
Guidance > Enter the guidance mode
swit
ch ？/ok/err turn on/off the focus motor 1
set A ？/ok/err set the point A of focus motor 1
set B ？/ok/err set the point B of focus motor 1
Clear AB ？/ok/err Clear the calibration information
Guidance > Enter the guidance mode
> Enter the dolly zoom mode
inception 0--100 set the rotation speed of inception mode
？/on/off turn on/off the motion control of tilt axis
？/on/off turn on/off the motion control of roll axis
？/on/
off turn on/off the motion control of pan axis
0-100 set the rotation speed of motion control
tracking 0-100 set the max speed of tracking
on/off turn on/off the manual positioning of tilt axis
on/off turn on/off the manual positioning of roll axis
on/off turn on/off the manual positioning of pan axis
？/ok calibrating/calibrated the gyroscope
？/ok calibrating/calibrated the accelerometer
0-100 set the offset value
of tilt axis
0-100 set the offset value of roll axis
0-100 set the offset value of pan axis
* switch display language to English
* switch display language to Chinese
？/ok save to configuration 1
？/ok load configuration 1
？/ok save to configuration 2
？/ok load configuration 2
？/ok save to configuration 3
？/ok load configuration 3
？/ok restore default parameter settings
device name and firmware information
habits
LED
switch
brightness
advance
d
autotune
i
Focus
F1
m
anual pos
dolly zoom
speed
m
otion sensin
g
switch
tilt
roll
pan
speed
c
alibration
gyro
acc
angle offset
tilt
roll
pan
general
l
anguage
English
中文
c
onfig
config1
save
load
config2
save
config3
save
load
reset
about
tilt
roll
pan
load
speed
F2
operationgimbal