User's Manual

14
The payload of AirCross 2 is from 300g to 3200g. Different payload requires
different motor power to achieve the best stability. There are three methods for
adjusting the output of the motor:
Auto-tuning operation method:
a. Install the camera and adjust the balance
b. Unlock all motor locks
c. Turn on the stabilizer, long press the center button to enter the menu, select
‘Gimbal’ > 'Motor' > ‘Power’ > ‘Auto-tune’
d. During the auto-tuning, the stabilizer will vibrate automatically to match the
most suitable output value. Wait for about 5 seconds, the stabilizer stops
shaking, and the auto-tuning completes.
Set the output gear:
Factory default presets 5 groups of motor output values, which are suitable for
cameras of different weight levels.
Customize the output value of each motor:
The users can customize the output value of each motor to reach more precise
control of the motor output. The adjustment range is 0 to 100.
Note:
1. Cameras equipped with Micro USB 3.0 interface, such as the Nikon D850,
can be normally controlled by half plugging the M3C-Micro cable.
2. After plugging the camera control cable, please operate the camera
according to the prompts on the camera screen, otherwise the camera
control function may not work properly.
Note:
1. Under the camera lens combination of the limit, the auto-tuning function may not
accurately calculate the appropriate output value. Please manually adjust the motor output
according to the situation.
2. If the motor output is too low, the video is not stable enough; if the motor output is too high,
it will cause high-frequency vibration of the stabilizer.
3. When the motor output is at the critical value, the stabilizer will not vibrate in the upright
state, but it will vibrate in the forward or inverted state. Please reduce the motor output
moderately.
Motor Output
camera > motor > switch autotune
gimbal > follow > power > level >
advanced > operation > filter > custom >
general >
b. Refer to the list to choose and connect the camera control cable. Connect the Mini-USB end of
the control cable to the control port of AirCross 2. Connect the other end to the corresponding
control port of the camera.
c. You can achieve recording by clicking the menu button one time and taking photos by clicking
menu button twice after selecting the camera type and connecting the camera control cable.