User's Manual

16
Inception Mode
Button Customization
Manual positioning is used to quickly adjust the direction of the camera. When
the function of manual positioning is enabled, the camera orientation can be
adjusted by hand which will not automatically return to the initial position. The
adjustment speed is faster than using the joystick or the following mode.
The manual positioning of the tilt and pan axis are enabled by default on the
AirCross 2. Manual positioning of the roll axes can be enabled in the menu.
The Inception Mode is used to control the camera to rotate in the roll
direction for shooting upside down and rotating footages. In the main
interface, triple click the right button to enter the Inception Mode.
After entering the Inception Mode, the camera lens is vertically up and
each axis automatically follows.
Button Definition for Inception Mode:
● Turn the joystick left or right: the gimbal turns to left or right, when
The higher the sensitivity of the button, the more sensitive and faster the
control is. If you change the 'custom' to -, the direction of operation will be
opposite. For more button customization, please refer to
Page11 Menu
Description.
Note: The follow function has higher priority than manual positioning.
When the follow function of any axis is on, the manual positioning
function cannot be used. Only after the follow function is off, the
manual positioning can be used normally.
Manual Positioning
off
off
相机
高级
通用
pan
Button Customization is used to specify the function, sensitivity and
operation direction of each button according to the user's habits.
For Example:
By default, moving the joystick up and down controls the tilt axis rotation.
It can be changed to control the roll or pan axis rotation by customizing;
By default, moving the joystick left and right controls the pan axis
rotation. It can be changed to control the tilt or roll axis rotation by
customizing.
release or turn to a specified angle, the gimbal stops.
● Turn the dial: adjust the rotation speed
● Press the left button on the dial once: the gimbal rotates to the left
automatically.If the gimbal is rotating, press once to stop.
● Press right button on the dial once: the gimbal rotates to the right
automatically.If the gimbal is rotating, press once to stop.
● Press up/down button on the dial: select rotationangle
● Normal: gimbal rotatesand does not stop automatically
● 180: the gimbal rotates 180° and stops automatically.
● 360: the gimbal rotates 360° and stops automatically.
camera > inception tilt [off] tilt [on]
g
imbal > motion sensing >
>
roll [off] roll [off]
a
dvanced > tracking > pan [ on] pan [ on]
g
eneral > manual pos >
camera > motor > joystick > function > left-right [p]
g
imbal > follow > wheel > sensitivity > up-down [t]
a
dvanced > operation > trigger > habits >
g
eneral > dial >