User's Manual

17
Balance Check
The Inception Mode is used to control the camera to rotate in the roll
direction for shooting upside down and rotating footages. In the main
interface, triple click the right button to enter the Inception Mode.
After entering the Inception Mode, the camera lens is vertically up and
each axis automatically follows.
Button Definition for Inception Mode:
● Turn the joystick left or right: the gimbal turns to left or right, when
The gimbal can check the balance status of the tilt and roll axis
automatically and instruct users to make the correct adjustment.
a. Attach a tripod to the gimbal, turn on the gimbal and place it on a
horizontal tabletop.
b. Enter the menu, select advanced>balance chk, the gimbal begins to
check the balance adjustment.
c. When balance check is completed, the balance status of each axis will
be displayed on the screen, direction guide will be also displayed if the
adjustment is needed.
d. C means quick release plate, T means tilt axis, R means roll axis, the
direction can be viewed at the corresponding position of the gimbal,
then start the adjustment according to the screen prompts.
e. When adjustment is completed, press the right button and check it
again until the gimbal is well balanced.
Note: Balance check can be only used with the tilt and roll axis, the
pan axis balance can’t be checked. When exit balance check, a
notice that user need to check and balance pan axis manually will
appear on the screen. Be sure that the motor lock has been released
when using balance check.
Triple click the right button again to exit the Inception Mode.
release or turn to a specified angle, the gimbal stops.
● Turn the dial: adjust the rotation speed
● Press the left button on the dial once: the gimbal rotates to the left
automatically.If the gimbal is rotating, press once to stop.
● Press right button on the dial once: the gimbal rotates to the right
automatically.If the gimbal is rotating, press once to stop.
● Press up/down button on the dial: select rotationangle
● Normal: gimbal rotatesand does not stop automatically
● 180: the gimbal rotates 180° and stops automatically.
● 360: the gimbal rotates 360° and stops automatically.
camera > autotune C adjust to +
gimbal > balance chk checking T adjust to -
advanced > iFocus > R well balanced
general > inception > exit
Inception Mode
< Speed：50 >
Normal 180 360
Inception Mode
< Speed：50 >
Inception Mode
< Speed：50 >
Normal 180 360Normal 180 360