User's Manual

19
User Configuration Management
The AirCross 2 can save 3 groups of user data like camera type, motor
output, button operations and other parameters, so users can retrieve
relevant parameters previously used and avoid trouble of setting
parameters each time when changing the camera.
Extensible electronic accessories
AirCross 2 can assemble 2 iFocus M motors to control focus ring and zoom
ring of the lens, please connect the CAN port of AirCross 2 and iFocus M
via Multi-CAN cable, and set the smart wheel to 'F1' or 'F2' mode, then
you can control iFocus M motor with the smart wheel AirCross 2 and
slypod can be assembled together to form a 4-axis linkage photography
system.
When configuration data is confusing, users can select “restore
configuration” to clear all previous configuration data.
Notes:
1.The offset can only adjust the angle of each axis within the range of about ±5°, if
there is too much offset, the camera cannot be completely leveled. 2.Offset is only
a temporary solution, after shooting, accelerometer calibration is still needed. 3.The
parameters of the offset will not be saved and will become invalid after restart.
The AirCross 2 supports both Chinese and English. After turning on the
gimbal, users can switch language in the menu.
Language Switch
Extension
camera > iFocus > gyro tilt [0] tilt [1]
gimbal > inception > acc roll [0] roll [0]
advanced > manual po
s >
>
a
ngle offs
et
> pan [0] pan [0]
general > calibration >
camera > language > English English *
gimbal > config > 中文 * 中文
advanced >
general >
about
camera > language > config1 > save
gimbal > config > config2 > load
advanced > config3 >
general >
about
reset